LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis (Single Page) >> Electrical >> Wiring Diagrams >> Wiring Systems & Electrical Power Management >> Diagnostic Information and Procedures >> Pull to Seat Connectors >> Terminal Installation

Terminal Installation

  1. Align the terminal and pull the wire from the back of the connector in order to seat the terminal.
  2. If necessary, cut the new wire to proper length and splice with existing circuit. Refer to Splicing Copper Wire Using Splice Sleeves .
  3. If the connector is outside of the passenger compartment, apply dielectric grease to the connector.
  4. Install the TPA, CPA and/or the secondary locks.
scientia non olet · About LEMON Manuals