LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Venture LT, FWD >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt System >> Diagnostic Information and Procedures >> Seat Belt Indicator Circuit Malfunction

Seat Belt Indicator Circuit Malfunction

Seat Belt Indicator Circuit Malfunction

Step Action Yes No
Schematic Reference: Seat Belt Schematics 
1 Did you perform the Diagnostic System Check - Seat Belts? Go to Step 2  Go to Diagnostic System Check - Seat Belts 
2
  1. Turn ON the ignition, with the engine OFF.
  2. Monitor the fasten safety belt indicator while buckling and unbuckling the driver seat belt.
Does the system operate properly?		 Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3 With the driver seat belt buckled, use the scan tool to observe the Driver Side Belt Status parameter in the SIR scan tool data list.
Does the scan tool indicate that the Driver Side Belt Status parameter displays Buckled?		 Go to Step 4  Go to Step 7 
4
  1. Turn OFF the ignition.
  2. Disconnect the body control module (BCM) connector C2. Refer to Body Control Module Replacement in Body Control System.
  3. Disconnect the seat belt switch - LF connector. Refer to Seat Belt Buckle Pretensioner Replacement - LH in SIR.
  4. Test the seat belt switch - LF signal circuit for an open or high resistance.
Did you find and correct the condition?		 Go to Step 10  Go to Step 5 
5 Test the seat belt switch - LF ground circuit for an open or high resistance.
Did you find and correct the condition?		 Go to Step 10  Go to Step 6 
6
  1. Test the seat belt switch - LF for an open.
  2. Replace the seat belt switch - LF if it is malfunctioning. Refer to Seat Belt Buckle Pretensioner Replacement - LH .
Did you find and correct the condition?		 Go to Step 10  Go to Step 9 
7
  1. Turn OFF the ignition.
  2. Disconnect the body control module (BCM) connector C2. Refer to Body Control Module Replacement in Body Control System.
  3. Disconnect the seat belt switch - LF connector. Refer to Seat Belt Buckle Pretensioner Replacement - LH in SIR.
  4. Test the seat belt switch - LF signal circuit for a short to voltage or a short to ground.
Did you find and correct the condition?		 Go to Step 10  Go to Step 8 
8
  1. Test the seat belt switch - LF for a short.
  2. Replace the seat belt switch - LF if it is malfunctioning. Refer to Seat Belt Buckle Pretensioner Replacement - LH .
Did you find and correct the condition?		 Go to Step 10  Go to Step 9 
9 Replace the IPC. Refer to Instrument Panel Cluster (IPC) Replacement in Instrument Panel, Gages, and Console.
Did you complete the replacement?		 Go to Step 10  -
10 Operate the system in order to verify the repair.
Did you find and correct the condition?		 System OK Go to Step 3 
scientia non olet · About LEMON Manuals