Charge Indicator Inoperative
Charge Indicator Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you perform the Engine Electrical Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Engine Electrical |
| 2 | Turn ON the ignition, with the engine OFF. Does the battery charge indicator illuminate? |
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 | Test the Generator Turn-On Signal circuit for a high resistance or open. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 6 | Go to Step 4 |
| 4 | Inspect for poor connections at the PCM harness connector. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 6 | Go to Step 5 |
| 5 |
IMPORTANT:
Perform the set up procedures for the PCM. Replace the PCM. Refer to Powertrain Control Module (PCM) Replacement
in Engine Controls - 3.4L.Did you complete the replacement? |
Go to Step 6 | - |
| 6 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |