LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Venture LT, FWD >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Battery, Charging System And Starting System >> Diagnostic Information and Procedures >> Charge Indicator Always On

Charge Indicator Always On

Charge Indicator Always On

Step Action Value(s) Yes No
1 Did you perform the Engine Electrical Diagnostic System Check? - Go to Step 2  Go to Diagnostic System Check - Engine Electrical 
2 Start the engine.
Does the battery charge indicator remain illuminated?
- Go to Step 3  Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
3
  1. Install a scan tool
  2. With a scan tool, observe the Ignition 1 Signal parameter in the PCM data list.
Does the scan tool indicate that the Ignition 1 Signal parameter is within the specified range?
10-15 V Go to Step 4  Go to Charging System Test 
4
IMPORTANT: Perform the set up procedures for the PCM.
Replace the PCM. Refer to Powertrain Control Module (PCM) Replacement in Engine Controls - 3.4L.Did you complete the replacement?
- Go to Step 5  -
5 Operate the system in order to verify the repair.
Did you correct the condition?
- System OK Go to Step 2