LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Venture LT, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Trim Plate Replacement - Instrument Panel (I/P) Accessory >> Installation Procedure

Installation Procedure

    Fig 1: View Of IP Accessory Trim Plate
    GM318192Courtesy of GENERAL MOTORS CORP.
  1. Install the IP accessory trim plate to the instrument panel.
  2. Connect the electrical connectors, if equipped.
  3. Align the upper tabs of the IP accessory trim plate to the instrument panel.
  4. Install the following sets of screws:
    • Two screws to the front of the trim panel
    • Two screws to the bottom of the trim panel
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Tighten all of the screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  6. Install the console storage box, if required.
  7. Install the ashtray or the cupholder, if required.
  8. Close the ashtray or the cupholder.
scientia non olet · About LEMON Manuals