LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Venture LT, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Instrument Panel Cluster (IPC) Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Locating Electrical Connectors
    GM318187Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connectors.
    2. Fig 2: View Of Instrument Panel Cluster
    GM318190Courtesy of GENERAL MOTORS CORP.
  2. Position the IP cluster to the instrument panel.
    3. Fig 3: Locating Screws To Instrument Panel Cluster
    GM182576Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screws to instrument panel cluster.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  4. Install the instrument cluster trim plate. Refer to Trim Panel Replacement - Instrument Panel (I/P) Cluster .

    When installing a new IP cluster it must be synchronized to the supplemental inflatable restraint (SIR) module in order to synchronize the new cluster. Refer to Instrument Panel Cluster (IPC) Programming/Synchronization  and to Electronic Compass Calibration .

scientia non olet · About LEMON Manuals