LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Venture LT, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Instrument Panel (I/P) Carrier Replacement >> Removal Procedure

Removal Procedure

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical
  2. Remove the instrument panel. Refer to Instrument Panel (I/P) Assembly Replacement .
  3. Remove the body control module. Refer to Body Control Module Replacement in Body Control System.
  4. Remove the DRL module. Refer to Daytime Running Lights (DRL) Control Module Replacement in Lighting Systems.
  5. Remove the EBTCM module. Refer to Electronic Brake Control Module Replacement in Anti-lock Brake System.
  6. Remove the steering column. Refer to Steering Column Replacement in Steering Wheel and Column.
  7. Remove the A/C module. Refer to HVAC Control Module Replacement in Heating, Ventilation and Air Conditioning.
  8. Remove the IP air outlet ducts. Refer to Instrument Panel (I/P) Air Outlet Ducts Replacement in Heating, Ventilation and Air Conditioning.
  9. Remove the center air outlet. Refer to Air Outlet Replacement - Center in Heating, Ventilation and Air Conditioning.
  10. Remove the defroster duct. Refer to Air Outlet Duct Replacement - Defroster in Heating, Ventilation and Air Conditioning.
    11. Fig 1: View Of Bolts/Screws For IP Carrier And Cross Vehicle Beam To Hinge Pillar
    GM482588Courtesy of GENERAL MOTORS CORP.
  11. Remove the bolts/screws which secure the IP carrier to the body.
  12. Remove the IP carrier from the body.
scientia non olet · About LEMON Manuals