Installation Procedure

Fig 1: View Of Instrument Panel Trim Plate

Courtesy of GENERAL MOTORS CORP.

Position the instrument panel accessory trim plate in order to install the control switches.
- Install the selectable 4WD switch, if equipped. Refer to Transfer Case Shift Control Switch Replacement or Transfer Case Shift Control Switch Replacement in Transfer Case.
- Install the inflatable restraint IP module switch. Refer to Inflatable Restraint Instrument Panel (I/P) Module Disable Switch Replacement in SIR.
- Install the headlamp switch. Refer to Headlamp Switch Replacement in Lighting Systems.
Install the instrument panel accessory trim plate clips to the instrument panel.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws that retain the instrument panel accessory trim plate to the instrument panel.
Tighten: Tighten the screws to 1.9 N.m (17 lb in).
Install the knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster .
Install the left instrument panel sound insulator. Refer to Closeout/Insulator Panel Replacement - Left .