LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> S10 Pickup >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Trim Panel Replacement - Knee Bolster >> Installation Procedure

Installation Procedure

    Fig 1: View Of Knee Bolster Trim Panel
    GM303362Courtesy of GENERAL MOTORS CORP.
  1. Install the knee bolster trim panel to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screws that retain the knee bolster trim panel to the I/P.

    Tighten: 

    • Tighten the TORX® screws to 9 N.m (80 lb in).
    • Tighten the hex head screws to 1.9 N.m (17 lb in).

  3. Install the screw that retains the courtesy lamp to the knee bolster. Refer to Courtesy Lamp Replacement - Instrument Panel (Lower) in Lighting Systems.
  4. Install the park brake release cable to the park brake lever. Refer to Park Brake Release Handle Assembly Replacement in Park Brake.
  5. Install the lower I/P sound insulator. Refer to Closeout/Insulator Panel Replacement - Instrument Panel (I/P) Lower .
  6. Install the left side I/P sound insulator. Refer to Closeout/Insulator Panel Replacement - Left .
scientia non olet · About LEMON Manuals