LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> S10 Pickup >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Console Replacement - Front Floor (Full-Length (Manual Trans)) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Console
    GM303478Courtesy of GENERAL MOTORS CORP.
  1. Install the console to the vehicle.
  2. Connect the electrical connector, if equipped.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the nuts that retain the console to the vehicle.

    Tighten:  Tighten the nuts to 10 N.m (88 lb in).

    4. Fig 2: Identifying Console Compartment Inserts
    GM392688Courtesy of GENERAL MOTORS CORP.
  4. Install the storage compartment to the vehicle.
    5. Fig 3: View Of Console
    GM303465Courtesy of GENERAL MOTORS CORP.
  5. Install the trim plate to the console.
  6. Install the screws that retain the trim plate to the console.

    Tighten:  Tighten the nuts to 1.9 N.m (17 lb in).

  7. Install the cup holder insert.
  8. Install the shift control lever. Refer to Control Lever and/or Boot Replacement in Manual Transmission- NV 3500.
scientia non olet · About LEMON Manuals