LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> S10 Pickup >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Console Replacement - Front Floor (Full Length (Auto Trans)) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Console
    GM303478Courtesy of GENERAL MOTORS CORP.
  1. Install the console to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screws that retain the front of the console.

    Tighten:  Tighten the screws to 7 N.m (63 lb in).

  3. Install the cup holder insert.
  4. Install the nuts that retain the rear of the console.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

    5. Fig 2: Locating Transmission Select Switch
    GM392698Courtesy of GENERAL MOTORS CORP.
  5. Install the transmission select switch (if equipped).
    6. Fig 3: Identifying Console Compartment Inserts
    GM392688Courtesy of GENERAL MOTORS CORP.
  6. Install the console compartment insert.
  7. Install the console compartment insert screws.

    Tighten:  Tighten the nuts to 1.9 N.m (17 lb in).

    8. Fig 4: View Of Shift Handle
    GM392693Courtesy of GENERAL MOTORS CORP.
  8. Install the shift handle to the shift lever.
  9. Install the shift handle retaining clip at the front of the handle.
scientia non olet · About LEMON Manuals