LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> S10 Pickup >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Closeout/Insulator Panel Replacement - Left >> Installation Procedure

Installation Procedure

    Fig 1: View Of Instrument Panel Sound Insulator
    GM303358Courtesy of GENERAL MOTORS CORP.
  1. Install the remote control door lock receiver module to the instrument panel sound insulator.
  2. Connect the electrical connector to the remote door lock receiver module.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screw that retains the instrument panel sound insulator to the cowl panel.

    Tighten:  Tighten the screw to 1.9 N.m (17 lb in).

  4. Install the screws that retain the instrument panel sound insulator to the knee bolster.

    Tighten:  Tighten the screws to 1.9 N.m (17 lb in).

  5. Feed the DLC through the hole in the instrument panel sound insulator.
  6. Install the screws that retain the DLC to the instrument panel sound insulator.

    Tighten:  Tighten the screws to 2.4 N.m (21 lb in).

scientia non olet · About LEMON Manuals