LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> S10 Pickup >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Closeout/Insulator Panel Replacement - Instrument Panel (I/P) Lower >> Installation Procedure

Installation Procedure

  1. Connect the electrical connector to the accessory power outlet, if equipped.
    2. Fig 1: View Of instrument Panel Sound Insulator
    GM303359Courtesy of GENERAL MOTORS CORP.
  2. Install the instrument panel sound insulator to the vehicle.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screws that retain the instrument panel sound insulator to the following components:
    • The knee bolster
    • The instrument panel
    • The floor duct

      Tighten:  Tighten the screws to 1.5 N.m (13 lb in).

  4. Install the screw that retains the instrument panel sound insulator to the heater assembly.

    Tighten:  Tighten the screw to 1.5 N.m (13 lb in).

  5. Install the center console to the vehicle if equipped with RPO code YC7 (GMC Envoy). Refer to Console Replacement - Front Floor (Full Length (Auto Trans)) , Console Replacement - Front Floor (Full Length (Envoy)) , Console Replacement - Front Floor (Non-Full Length)  or Console Replacement - Front Floor (Full-Length (Manual Trans)) .
scientia non olet · About LEMON Manuals