Chime Always On
Chime Always On
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Audible Warnings Schematics Connector End View Reference: Instrument Panel, Gages, and Console Connector End Views or Body Control System Connector End Views |
|||
| 1 | Did you perform the Audible Warnings Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Audible Warnings |
| 2 |
|
Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems |
| 3 | Do any indicators illuminate when the chime sounds? | Go to Symptoms - Instrument Panel, Gages and Console | Go to Step 4 |
| 4 |
|
Go to Step 8 | Go to Step 5 |
| 5 | Test the key in ignition signal circuit for a short to ground. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 6 |
| 6 | Inspect for poor connections at the harness connector of the ignition key alarm switch. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 7 |
| 7 | Replace the ignition switch. Refer to Ignition Switch Replacement
in Steering Wheel and Column. Did you complete the replacement? |
Go to Step 9 | - |
| 8 |
IMPORTANT:
Program the replacement BCM. Replace the BCM. Refer to Body Control Module Replacement
in Body Control System.Did you complete the replacement? |
Go to Step 9 | - |
| 9 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |