LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Monte Carlo LS >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System >> Diagnostic Information and Procedures >> Engine Coolant Temperature Indicator Always On

Engine Coolant Temperature Indicator Always On

Engine Coolant Temperature Indicator Always On

Step Action Yes No
Connector End View Reference:  Cooling System Connector End Views  
DEFINITION: The engine coolant temperature indicator is always ON and no powertrain DTCs have been set.
1 Did you perform the Engine Cooling Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Engine Cooling 
2 Start the engine.
Does the Engine Coolant Temperature indicator illuminate?		 Go to Step 3  Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
3
  1. Connect the diagnostic scan tool.
  2. With the scan tool, observe the engine coolant temperature (ECT) sensor parameter in the Powertrain Control Module data list.
Does the scan tool indicate that the coolant temperature is within the temperature range shown on the temperature gauge?		 Go to Engine Overheating  Go to Step 4 
4 Replace the instrument panel cluster. Refer to Instrument Panel Cluster (IPC) Replacement in Instrument Panel Gages and Console.
Is the replacement complete?		 Go to Step 5  -
5 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 3 
scientia non olet · About LEMON Manuals