Removal Procedure
- Apply the park brake.
- Shift the transaxle shift lever from Park to 2.
- Remove the front floor console trim plate screw (1) located between the instrument panel and the shift lever.
Courtesy of GENERAL MOTORS CORP.
- Open the storage compartment door.
- Lift the trim plate up and slightly rearward.
- Remove the wiring harnesses from the retainers.
- Disconnect the traction control switch electrical connector.
- Remove the shift lever trim plate.
- Disconnect the heated seat switches from the trim plate.
- Remove the trim plate by lifting the trim plate slightly and rotating the trim plate 180 degrees. Lift the trim plate over the shift control handle.
- Disconnect the electrical connector from the cigarette lighter.
Courtesy of GENERAL MOTORS CORP.