LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Malibu Maxx >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions - 3 Of 5)) >> Off-Vehicle Repair Instructions (Part 2) >> Piston, Connecting Rod, Bearings Cleaning and Inspection >> Connecting Rod Cleaning Procedure

Connecting Rod Cleaning Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the connecting rods in solvent.
    2. CAUTION: Refer to Safety Glasses Caution in Cautions and Notices.
  2. Dry the connecting rod using compressed air.
  3. Remove the connecting rod cap and clean the threads.
  4. Remove the connecting rod bearing and discard. Never reuse a connecting rod bearing used in a running engine.
scientia non olet · About LEMON Manuals