LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Malibu Maxx >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions - 3 Of 5)) >> Off-Vehicle Repair Instructions (Part 2) >> Engine Front Cover Assemble >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Crankshaft Front Oil Seal
    GM1408429Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not lubricate the crankshaft front oil seal or crankshaft balancer sealing surfaces. The crankshaft balancer is installed into a dry seal.
  1. Install the NEW crankshaft front oil seal into the engine front cover using the J 29184  . See Special Tools .
    2. Fig 2: Identifying Front Oil Seal
    GM1579266Courtesy of GENERAL MOTORS CORP.
  2. Place the seal into position with the notches (1) in the seal down. The notches (1) will face in board when properly installed.
    3. Fig 3: Installing camshaft position actuator valve oil seals
    GM1408431Courtesy of GENERAL MOTORS CORP.
  3. Install the NEW camshaft position actuator valve oil seals into the engine front cover using the EN 46103  . See Special Tools .
scientia non olet · About LEMON Manuals