LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Malibu Maxx >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions -- 1 Of 5)) >> On-Vehicle Repair Instructions - Part 1 >> Drive Belt Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the right engine splash shield. Refer to Splash Shield Replacement - Engine in Body Front End.
  2. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    3. Fig 1: Drive Belt Routing &Tensioner 3.6L
    GM1394083Courtesy of GENERAL MOTORS CORP.
  3. Install the drive belt to the accessory drive pulley.
  4. Rotate the drive belt tensioner clockwise.
  5. Install the drive belt to the generator.
    6. IMPORTANT: Ensure the drive belt is properly aligned and seated into the grooves of the accessory drive pulleys.
  6. Slowly release the drive belt tensioner.
scientia non olet · About LEMON Manuals