Security Indicator Inoperative
Security Indicator Inoperative Test
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Theft Deterrent System Schematics Connector End View Reference: Theft Deterrent System Connector End Views |
|||
| 1 | Did you perform the Vehicle Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 |
|
Go to Step 6 | Go to Step 4 |
| 4 | Test for an open or short to battery in the security indicator control circuit. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 5 |
| 5 | Inspect for poor connections at the harness connector of the instrument cluster. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 7 |
| 6 | Inspect for poor connections at the harness connector of the BCM. Refer toTesting for Intermittent Conditions and Poor Connections
andConnector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 8 |
| 7 | Replace the instrument cluster. Refer to Instrument Panel Cluster (IPC) Replacement
in Instrument Panel, Gages and Console. Did you complete the replacement? |
Go to Step 9 | - |
| 8 |
IMPORTANT:
Perform the setup procedure for the BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration
in Computer/Integrating Systems. Replace the BCM. Refer to Body Control Module Replacement
in Computer/Integrating Systems.Did you complete the replacement? |
Go to Step 9 | - |
| 9 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |