Scan Tool Data List
The scan tool data lists contain all the instrument panel, gages, and console related parameters that are available on the scan tool. The parameters in the list are arranged in alphabetical order. The data list column indicates the location of the parameter within the scan tool menu selections.
Use the scan tool data lists as directed by a diagnostic table or in order to supplement the diagnostic procedures. Begin all of the diagnostic procedures with the Diagnostic System Check - Vehicle in Vehicle DTC Information.
Use the scan tool data lists only after the following is determined:
- There is no published DTC procedure nor published symptom procedure for the customer concern.
- The DTC or symptom procedure indicated by the diagnostic system check does not resolve the customer concern.
The typical data values are obtained from a properly operating vehicle under the conditions specified in the first row of the scan tool data list table. Comparison of the parameter values from the suspect vehicle with the typical data values may reveal the source of the customer concern.
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Ignition ON/Engine OFF/Seat Belt Buckled/High Beams OFF/Park Brake Unapplied | |||
| DIC Switch | BCM | Clear/Info./Menu/Reset | Clear |
| Driver Door Ajar Switch | BCM | Door Closed/Door Ajar | Door Closed |
| Key In Ignition Cylinder Switch | BCM | Yes/No | Yes |
| Park Lamp Switch | BCM | On/Off | Off |
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Ignition ON/Engine OFF/Seat Belt Buckled/High Beams OFF/Park Brake Unapplied | |||
| Battery Voltage Signal | IPC | Volts | Varies |
| Chime | IPC | On/Off | Off |
| Ignition Status | IPC | On/Off | Off |
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Engine Idling/Normal Operating Temperature | |||
| Change Oil Now Command | PCM | On/Off | Off |
| Cruise Control Active | PCM | Yes/No | No |
| ECT Sensor | PCM | Celsius (Fahrenheit) | 85-105°C (185-220°F) |
| Engine Hot Lamp Command | PCM | On/Off | Off |
| Engine Oil Life Remaining | PCM | % | 0-100% Varies |
| Engine Oil Pressure Switch | PCM | OK/Low | OK |
| Engine Speed | PCM | RPM | +/-100 RPM from Desired Idle Speed |
| Fuel Level Sensor | PCM | Volts | Varies |
| Fuel Tank Level Remaining | PCM | % | 0-100% Varies |
| Generator Lamp Command | PCM | On/Off | Off |
| Ignition 1 Signal | PCM | Volts | Varies |
| Low Engine Oil Level Lamp Command | PCM | On/Off | Off |
| Low EOP Lamp Command | PCM | On/Off | Off |
| MIL Circuit History | PCM | OK/High/ Low | OK |
| MIL Circuit Status | PCM | OK/High/ Low | OK |
| MIL Command | PCM | On/Off | Off |
| Non-Driven Wheel Speed | PCM | kph (mph) | 0 kph (0 mph) |
| Odometer | PCM | kilometers (miles) | Varies |
| Reduced Engine Power | PCM | On/Off | Off |
| Vehicle Speed Sensor | PCM | kph (mph) | 0 kph (0 mph) |