LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Impala Police >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Trim Plate Replacement - Front Floor Console (Monte Carlo) >> Installation Procedure

Installation Procedure

  1. Lower the front floor console trim plate over the shift control handle as shown. Rotate the trim plate 180 degrees.
  2. Connect the electrical connector to the cigarette lighter.
  3. Connect the heated seat switches to the trim plate:
    • The driver seat connector is white.
    • The passenger seat connector is black.
  4. Install the shift lever trim plate.
  5. Connect the traction control switch electric connector.
  6. Install the wiring harnesses to the retainers.
  7. Install the trim plate by pressing down on the retainers until fully seated.
    8. Fig 1: Installing Trim Plate (Monte Carlo)
    GM601218Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  8. Install the trim plate screw (1) located between the instrument panel and the shift lever.

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

    9. Fig 2: Identifying Front Floor Console Trim Plate Screw (Monte Carlo)
    GM578742Courtesy of GENERAL MOTORS CORP.
  9. Shift the transaxle shift lever from 2 to Park.
  10. Release the park brake.
scientia non olet · About LEMON Manuals