LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Impala Police >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Impala) >> Removal Procedure

Removal Procedure

  1. Apply the parking brake.
  2. Using a small flat-bladed tool, remove the bezel from the ignition switch cylinder.
    3. Fig 1: Ignition Switch Cylinder Bezel (Impala)
    GM658401Courtesy of GENERAL MOTORS CORP.
  3. If the vehicle is equipped with a column shift, position the transaxle shift control indicator to 1. Keep the key in the ignition switch cylinder.
    4. Fig 2: Positioning Transaxle Shift (Impala)
    GM678301Courtesy of GENERAL MOTORS CORP.
  4. Adjust the steering wheel for access.
  5. Remove the steering column filler panel. Refer to Steering Column Filler Replacement .
  6. Remove the instrument panel (I/P) fuse block access hole covers.
    7. Fig 3: I/P Fuse Block Access Hole Covers (Impala)
    GM519536Courtesy of GENERAL MOTORS CORP.
  7. Remove the screws from the I/P cluster trim plate.
  8. Starting at the right end of the I/P cluster, grasp the trim plate and pull rearward.
  9. Continue working around the I/P cluster trim plate until all of the retainers are released from the I/P trim pad.
  10. Disconnect the electrical connectors from the hazard switch and from the traction control switch, if equipped.
  11. Remove the I/P cluster trim plate.
    12. Fig 4: Removing I/P Cluster Trim Plate (Impala)
    GM578987Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals