LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Impala Police >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Impala) >> Installation Procedure

Installation Procedure

  1. Position the IP cluster trim plate to the I/P trim pad.
  2. Connect the electrical connectors to the hazard switch and to the traction control switch, if equipped.
  3. Press the IP cluster trim plate into the I/P trim pad until the retainers are fully seated.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the I/P cluster trim plate screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    5. Fig 1: Installing I/P Cluster Trim Plate (Impala)
    GM578987Courtesy of GENERAL MOTORS CORP.
  5. Install the I/P fuse block access hole covers.
    6. Fig 2: I/P Fuse Block Access Hole Covers (Impala)
    GM519536Courtesy of GENERAL MOTORS CORP.
  6. Align the bezel retainers to the tabs on the ignition switch cylinder.
    7. Fig 3: Aligning Bezel Retainers (Impala)
    GM658402Courtesy of GENERAL MOTORS CORP.
  7. Install the bezel to the ignition switch cylinder pressing into place until fully seated.
    8. Fig 4: Installing Bezel To Ignition Switch Cylinder (Impala)
    GM658399Courtesy of GENERAL MOTORS CORP.
  8. Install the steering column filler panel. Refer to Steering Column Filler Replacement .
  9. Return the steering wheel to the original position.
  10. If the vehicle is equipped with a column shift, position the transaxle shift control indicator to Park and remove the key from the ignition switch cylinder.
    Fig 5: Positioning Transaxle Shift (Impala)
    GM678301Courtesy of GENERAL MOTORS CORP.
  11. Release the parking brake.
scientia non olet · About LEMON Manuals