LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Impala Police >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Knee Bolster Bracket Replacement - Right >> Installation Procedure

Installation Procedure

  1. Align the IP passenger knee bolster bracket to the instrument carrier.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bracket bolts to the IP passenger knee bolster at the instrument carrier in the sequence shown.

    Tighten:  Tighten the bracket bolts to 10 N.m (89 lb in).

  3. Connect the wiring harness retainers to the IP passenger knee bolster bracket.
  4. Install the right IP accessory wiring junction block.
    5. Fig 1: Knee Bolster & Bracket
    GM455173Courtesy of GENERAL MOTORS CORP.
  5. Install the IP trim pad. Refer to Instrument Panel (I/P) Trim Panel Replacement - Lower (Impala)  or Instrument Panel (I/P) Trim Panel Replacement - Lower (Monte Carlo) .
scientia non olet · About LEMON Manuals