Installation Procedure
- Install the front floor console.
- Install the console bolts forward of the shift control lever and at the bottom of the storage bin.
Tighten: Tighten the console bolts to 12 N.m (106 lb in).
- Install the storage compartment mat.
- Close the console storage compartment.
- Connect the wiring harness connector and retainer.
- Install the front floor console trim plate. Refer to Trim Plate Replacement - Front Floor Console (Monte Carlo) or Trim Plate Replacement - Front Floor Console (Impala) .
NOTE:
Refer to Fastener Notice in Cautions and Notices.