LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Impala Police >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Diagnostic Information and Procedures >> Driver Information Center (DIC) Temperature Display Inaccurate or Inoperative >> Test Description

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. 3:  This step tests for a high resistance in the signal circuit and the ground circuit of the ambient air temperature sensor.
  2. 10:  DTCs may be set in the DIC when you perform this diagnostic table.
Driver Information Center (DIC) Temperature Display Inaccurate or Inoperative

Step Action Value(s) Yes No
Schematic Reference:  Driver Information System Schematics  
1 Did you perform the Driver Information Center Diagnostic System Check? - Go to Step 2  Go to Diagnostic System Check - Driver Information Systems 
2
  1. Turn the ignition ON, with the engine OFF.
  2. Set the DIC to the compass/temperature display.
Does the temperature displayed on the DIC match the current room temperature within 3°F (2°C)?		 - Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3 
  1. Disconnect the ambient air temperature sensor connector.
    2. IMPORTANT: Verify the J 33431-C  . See Special Tools  Signal Generator and Instrument Panel Tester resistance settings with a DMM.
  2. Set the resistance on the J 33431-C  . See Special Tools  Signal Generator and Instrument Panel Tester to 3047 Ω.
  3. Connect the J 33431-C  . See Special Tools  between the signal circuit of the ambient air temperature sensor and the ground circuit of the ambient air temperature sensor.
  4. Turn the ignition ON, with the engine OFF.
Does the DIC display the specified value?		 130°F (54°C) Go to Step 6  Go to Step 4 
4 Test the signal circuit of the ambient air temperature sensor for a high resistance. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 10  Go to Step 5 
5 Test the ground circuit of the ambient air temperature sensor for a high resistance. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 10  Go to Step 7 
6 Inspect for poor connections at the harness connector of the ambient air temperature sensor. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 10  Go to Step 8 
7 Inspect for poor connections at the harness connector of the DIC. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 10  Go to Step 9 
8 Replace the ambient air temperature sensor. Refer to Ambient Air Temperature Gage Sensor Replacement  .
Did you complete the replacement?		 - Go to Step 10  -
9
IMPORTANT: Calibrate the compass on the replacement DIC. Refer to Electronic Compass Calibration  .
Replace the DIC. Refer to Driver Information Center Replacement (UG1, EXC CF5) Driver Information Center Replacement (CF5)  .Did you complete the replacement?		 - Go to Step 10  -
10 
  1. Use the scan tool in order to clear the DIC DTCs.
  2. Operate the system in order to verify the repair.
Did you correct the condition?		 - System OK Go to Step 2 
scientia non olet · About LEMON Manuals