Speedometer and/or Odometer Inaccurate or Inoperative
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| 1 | Inspect fuse F12. Is fuse F12 open? |
- | Go to Step 2 | Go to Step 3 |
| 2 |
|
- | System OK | - |
| 3 |
|
11-14 V | Go to Step 5 | Go to Step 4 |
| 4 | Repair the power supply for the ignition 2 relay. Is the repair complete? |
- | System OK | - |
| 5 |
|
- | Go to DTC 024 or DTC P0502 in Engine Controls - 2.0L or DTC P0720 , DTC P0721 (European and N American Emissions) or DTC P0721 (Non Europe or N American Emissions) , or DTC P0722 in Automatic Transmission | Go to Step 6 |
| 6 |
|
11-14 V | Go to Step 8 | Go to Step 7 |
| 7 | Repair the open circuit between Fuse F12 and the instrument cluster. Is the repair complete? |
- | System OK | - |
| 8 | Use an ohmmeter to Measure the resistance between ground and instrument cluster connector terminal C5. Is the resistance near the specified value? |
0 Ω | Go to Step 10 | Go to Step 9 |
| 9 | Repair the open circuit between ground and instrument cluster connector terminal C5. Is the repair complete? |
- | System OK | - |
| 10 | Use an ohmmeter to Measure the continuity of the circuit wire between the vehicle speed sensor terminal B and instrument cluster connector terminal C7. Is the continuity near the specified value? |
0 Ω | Go to Step 12 | Go to Step 11 |
| 11 | Repair the open circuit between the vehicle speed sensor and the instrument cluster. Is the repair complete? |
- | System OK | - |
| 12 | Replace the instrument cluster. Refer to Instrument Panel Cluster (IPC) Replacement . Is the repair complete? |
- | System OK | - |