LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Automatic Transmission - 4L60-E/4L65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Transmission Fluid Cooler Hose/Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Transmission Oil Cooler Lines
    GM396804Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission oil cooler lines to the vehicle.
  2. Install the cooling lines to the transmission. Refer to Transmission Fluid Cooler Line Quick Connect Fitting .
    3. Fig 2: Transmission Fluid Cooler Hose To The Auxiliary Oil Cooler
    GM396817Courtesy of GENERAL MOTORS CORP.
  3. Install the engine protection shield. Refer to Engine Protection Shield Replacement in Frame and Underbody.
  4. Lower the vehicle.
  5. Install the transmission fluid cooler hose to the radiator. Refer to Transmission Fluid Cooler Line Quick Connect Fitting .
  6. Install the transmission fluid cooler hose to the Auxiliary oil cooler. Refer to Transmission Fluid Cooler Line Quick Connect Fitting .
  7. Install the front grill assembly. Refer to Grille Replacement (Cadillac) or Grille Replacement (Avalanche) or Grille Replacement (Chevrolet) or Grille Replacement (GMC) in Exterior Trim.
scientia non olet · About LEMON Manuals