LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Automatic Transmission - 4L60-E/4L65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Automatic Transmission Range Selector Cable Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Retainer Securing Cable To Bracket
    GM858985Courtesy of GENERAL MOTORS CORP.
  1. Apply the park brake.
  2. Shift the transmission into neutral.
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  4. Remove the retainer that secures the cable to the bracket.
  5. Depress the tangs and remove the cable from the bracket.
    6. Fig 2: View Of Selector Cable Bracket And Cable
    GM777649Courtesy of GENERAL MOTORS CORP.
  6. Remove the bolts (1) securing the transmission range selector cable bracket (2) to the transmission.
  7. Remove the transmission range selector cable bracket.
scientia non olet · About LEMON Manuals