LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Automatic Transmission - 4L60-E/4L65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Automatic Transmission Range Selector Cable Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Selector Cable Bracket And Cable
    GM777649Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission range selector cable bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the transmission range selector cable bracket bolts (1).

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    3. Fig 2: View Of Retainer Securing Cable To Bracket
    GM858985Courtesy of GENERAL MOTORS CORP.
  3. Align and install the cable to the bracket.
  4. Install the retainer that secures the cable to the bracket.
  5. Lower the vehicle.
  6. Check the vehicle for proper operation. If cable adjustment is necessary, refer to Automatic Transmission Range Selector Cable Adjustment .
scientia non olet · About LEMON Manuals