LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical (Repair Instructions -- 1 Of 3) -- 4.8L, 5.3L & 6.0L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Oil Level Indicator and Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the oil level indicator.
    2. Fig 1: View Of Oil Level Indicator
    GM1236365Courtesy of GENERAL MOTORS CORP.
  2. Remove the oil level indicator tube bolt.
  3. Remove the oil level indicator tube from the engine block.
    4. Fig 2: View Of Oil Level Indicator Tube & Bolt
    GM1236364Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The O-ring seal may be reused if not cut or damaged.
  4. Inspect the O-ring seal for cuts or damage.
  5. Remove the O-ring seal from the tube, if required.
scientia non olet · About LEMON Manuals