LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical (Repair Instructions -- 1 Of 3) -- 4.8L, 5.3L & 6.0L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Engine Sight Shield Replacement (6.0L (RPO LQ9)) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Loosen the intake manifold sight shield bolt.
  2. Remove the sight shield from the sight shield retainer.
    3. Fig 1: View Of Engine Sight Shield (6.0L - RPO LQ9)
    GM832097Courtesy of GENERAL MOTORS CORP.
  3. Loosen the left fuel rail cover bolts.
  4. Remove the left fuel rail cover.
  5. Remove the surge tank/heater hoses from the clip on the right fuel rail cover.
  6. Loosen the right fuel rail cover bolts.
  7. Remove the right fuel rail cover.
  8. Remove the sight shield retainer bolts and retainer, if required.
    9. Fig 2: View Of Engine Sight Shield Retainer & Bolts
    GM832095Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals