LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical (Repair Instructions -- 1 Of 3) -- 4.8L, 5.3L & 6.0L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Engine Sight Shield Replacement (4.8L, 5.3L, and 6.0L (RPO LQ4)) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the sight shield retainer and the bolts, if required.

    Tighten:  Tighten the bolts to 5 N.m (44 lb in).

    2. Fig 1: View Of Engine Sight Shield Retainer & Bolts
    GM832095Courtesy of GENERAL MOTORS CORP.
    NOTE: Use care when installing the engine sight shield to avoid contacting the manifold absolute pressure (MAP) sensor wire harness connector. Loss of engine performance or engine damage may result.
  2. Install the intake manifold sight shield to the retainer.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    3. Fig 2: View Of Engine Sight Shield (4.8L, 5.3L & 6.0L - RPO LQ4)
    GM832094Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals