LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical (Repair Instructions -- 1 Of 3) -- 4.8L, 5.3L & 6.0L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Right >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the exhaust manifold. Refer to Exhaust Manifold Replacement - Right (4.8L, 5.3L, and 6.0L Engines) in Engine Exhaust.
  2. Remove the engine mount-to-engine mount bracket bolts.
    3. Fig 1: View Of Engine Mount-To-Engine Mount Bracket
    GM307275Courtesy of GENERAL MOTORS CORP.
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  4. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Remove the inner wheelhouse panel. Refer to Refer to Wheelhouse Panel Replacement in Body Front End.
  6. Remove the engine protection shield, if equipped. Refer to Engine Protection Shield Replacement in Frame and Underbody.
    7. IMPORTANT: DO NOT raise and/or support the engine by the crankshaft balancer, or oil pan.
  7. Raise and suitably support the engine using adjustable (screw type) jack stands.
  8. Remove the engine mount to engine bolts.
  9. Remove the right engine mount.
    10. Fig 2: View Of Right Engine Mount & Bolts
    GM307279Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals