LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical (Repair Instructions -- 1 Of 3) -- 4.8L, 5.3L & 6.0L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Drive Belt Tensioner Replacement - Accessory >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the drive belt tensioner.
  2. Install the drive belt tensioner bolts.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the drive belt tensioner bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    4. Fig 1: View Of Drive Belt Tensioner & Bolts
    GM647789Courtesy of GENERAL MOTORS CORP.
  4. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
scientia non olet · About LEMON Manuals