LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical (Repair Instructions -- 1 Of 3) -- 4.8L, 5.3L & 6.0L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> Off-Vehicle Repair Instructions - Part 1 >> Oil Level Indicator and Tube Removal

Oil Level Indicator and Tube Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the oil level indicator from the tube.
  2. Remove the oil level indicator tube bolt.
  3. Remove the oil level indicator tube from the engine block.
    4. IMPORTANT: Inspect the O-ring seal for cuts or damage. The O-ring seal may be used again if it is not cut or damaged.
  4. Remove the O-ring seal from the tube, if required.
    5. Fig 1: View Of Oil Level Indicator, Tube & Tube Bolt
    GM260114Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals