LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical (Repair Instructions -- 1 Of 3) -- 4.8L, 5.3L & 6.0L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> Off-Vehicle Repair Instructions - Part 1 >> Engine Flywheel Removal

Engine Flywheel Removal

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: The flywheel does not use a locating pin for alignment and will not initially seat against the crankshaft flange or spacer, if applicable, but will be pulled onto the crankshaft by the engine flywheel bolts. This procedure requires a 3 stage tightening process.
  1. Remove the engine flywheel bolts.
  2. Remove the automatic transmission engine flywheel.
    3. Fig 1: View Of Engine Flywheel & Bolt
    GM178458Courtesy of GENERAL MOTORS CORP.
  3. Install 2 M11x1.5 mm bolts (1) into the threaded holes of the spacer, if applicable.
  4. Rotate the bolts clockwise to remove the spacer.
    5. Fig 2: Installing Bolts Into Threaded Holes Of Spacer
    GM642281Courtesy of GENERAL MOTORS CORP.
  5. Remove the spacer from the rear of the crankshaft, if applicable.
    6. Fig 3: View Of Spacer & Crankshaft Rear
    GM642276Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals