LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System - 4.8L, 5.3L & 6.0L (Introduction)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of MAP Sensor & Knock Sensor Electrical Connectors
    GM679510Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine sight shield. Refer to Engine Sight Shield Replacement (4.8L, 5.3L, and 6.0L (RPO LQ4)) or Engine Sight Shield Replacement (6.0L (RPO LQ9)) in Engine Mechanical-4.8L, 5.3L, and 6.0L.
  2. Disconnect the manifold absolute pressure (MAP) sensor electrical connector (1).
    3. Fig 2: View Of Manifold Absolute Pressure (MAP) Sensor
    GM863068Courtesy of GENERAL MOTORS CORP.
  3. Remove the MAP sensor (1).
scientia non olet · About LEMON Manuals