LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System - 4.8L, 5.3L & 6.0L (Introduction)) >> Repair Instructions >> Knock Sensor (KS) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Knock Sensors
    GM309864Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the knock sensors.

    Tighten:  Tighten the sensor to 20 N.m (15 lb ft).

    2. Fig 2: View Of Rubber Covers
    GM832149Courtesy of GENERAL MOTORS CORP.
  2. Connect the knock sensor electrical connectors.
  3. Push down on the rubber covers.
  4. Install the intake manifold. Refer to Intake Manifold Replacement in Engine Mechanical-4.8L, 5.3L, and 6.0L.
scientia non olet · About LEMON Manuals