LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System - 4.8L, 5.3L & 6.0L (Introduction)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement (2500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Pressure Sensor (2500 Series)
    GM1312086Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the seal on the fuel pressure sensor.
  2. Press the fuel pressure sensor (1) into the line.
  3. Install the intermediate fuel and EVAP lines. Refer to Fuel Hose/Pipes Assembly Replacement (1500 Series)  or Fuel Hose/Pipes Assembly Replacement (1500 Series - 5.3L (L59) Engine)  or Fuel Hose/Pipes Assembly Replacement (2500 Series - Front Tank)  or Fuel Hose/Pipes Assembly Replacement (2500 Series - Intermediate) .
scientia non olet · About LEMON Manuals