LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System - 4.8L, 5.3L & 6.0L (Introduction)) >> Repair Instructions >> Fuel Pressure Gage Installation and Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Fuel Pressure Gauge J 34730-1A
    GM180378Courtesy of GENERAL MOTORS CORP.
  1. Remove the bleed hose on the J 34730-1A  from the approved container. See Special Tools and Equipment .
  2. Remove the shop towel from around the fitting and discard into an approved container.
  3. Disconnect the J 34730-1A  from the fuel pressure valve. See Special Tools and Equipment .
  4. Install the fuel rail pressure fitting cap.
  5. Install the engine sight shield. Refer to Engine Sight Shield Replacement (4.8L, 5.3L, and 6.0L (RPO LQ4)) or Engine Sight Shield Replacement (6.0L (RPO LQ9)) in Engine Mechanical-4.8L, 5.3L, and 6.0L.
scientia non olet · About LEMON Manuals