LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System - 4.8L, 5.3L & 6.0L (Introduction)) >> Repair Instructions >> Fuel Level Sensor Replacement (6.0L Engine - Rear Tank) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Level Sensor (6.0L Engine - Rear Tank)
    GM1332910Courtesy of GENERAL MOTORS CORP.
  1. Remove the sending unit. Refer to Fuel Sender Assembly Replacement (4.8L and 5.3L Engines)  or Fuel Sender Assembly Replacement (5.3L (L59) Engine)  or Fuel Sender Assembly Replacement (6.0L Engine - Dual Tanks - Front)  or Fuel Sender Assembly Replacement (6.0L Engine - Dual Tanks - Rear) .
  2. Disconnect the level sensor electrical connector.
  3. Release the level sensor retaining clip.
  4. Squeeze the locking tangs together, and remove the fuel level sensor (1).
scientia non olet · About LEMON Manuals