LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System - 4.8L, 5.3L & 6.0L (Introduction)) >> Repair Instructions >> Fuel Level Sensor Replacement (4.8L and 5.3L Engines) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Electrical Connector Retainer
    GM1341841Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel sending unit. Refer to Fuel Sender Assembly Replacement (4.8L and 5.3L Engines)  or Fuel Sender Assembly Replacement (5.3L (L59) Engine)  or Fuel Sender Assembly Replacement (6.0L Engine - Dual Tanks - Front)  or Fuel Sender Assembly Replacement (6.0L Engine - Dual Tanks - Rear) .
  2. Push in the retainer in order to disengage the electrical connector.
    3. Fig 2: View Of Fuel Level Sensor Electrical Connector (4.8L & 5.3L)
    GM1341843Courtesy of GENERAL MOTORS CORP.
  3. Remove the fuel level sensor electrical connector.
    4. Fig 3: View Of Locking Tangs At Sending Unit Bucket
    GM1332659Courtesy of GENERAL MOTORS CORP.
  4. Push the locking tangs (1) in towards the interior of the sending unit bucket.
    5. Fig 4: View Of Fuel Level Sensor At Sending Unit Bucket (4.8L & 5.3L)
    GM1341846Courtesy of GENERAL MOTORS CORP.
  5. Slide the fuel level sensor up and out from the sending unit bucket.
scientia non olet · About LEMON Manuals