LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System - 4.8L, 5.3L & 6.0L (Introduction)) >> Repair Instructions >> Fuel Hose/Pipes Assembly Replacement (1500 Series) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: Clean the fuel feed pipe connection and surrounding area prior to disconnecting the fittings in order to avoid possible fuel system contamination.
    Fig 1: View Of Fuel Feed Line, EVAP Purge Line & EVAP Vent Lines (1500 Series)
    GM1312079Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement (Single Tank)  or Fuel Tank Replacement (Single Tank w/5.3L (L59) Engine)  or Fuel Tank Replacement (Dual Tanks - Front)  or Fuel Tank Replacement (Dual Tanks - Rear) .
  2. Disconnect and remove the fuel feed line (1) from the sending unit and retaining clips. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  3. Cap the fuel feed and evaporative emission (EVAP) openings in order to prevent possible fuel/EVAP system contamination.
scientia non olet · About LEMON Manuals