LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System - 4.8L, 5.3L & 6.0L (Introduction)) >> Repair Instructions >> Fuel Hose/Pipes Assembly Replacement (1500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Feed Line, EVAP Purge Line & EVAP Vent Lines (1500 Series)
    GM1312079Courtesy of GENERAL MOTORS CORP.
  1. Remove the caps from the fuel feed and EVAP lines.
  2. Install and connect the fuel feed (1) line to the sending unit and retaining clips. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  3. Install the fuel tank. Refer to Fuel Tank Replacement (Single Tank)  or Fuel Tank Replacement (Single Tank w/5.3L (L59) Engine)  or Fuel Tank Replacement (Dual Tanks - Front)  or Fuel Tank Replacement (Dual Tanks - Rear) .
scientia non olet · About LEMON Manuals