Removal Procedure
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Clean all the fuel and evaporative emission (EVAP) pipe connections and surrounding areas before disconnecting the pipes in order to avoid possible fuel/EVAP system contamination.
- Remove the fuel tank. Refer to Fuel Tank Replacement (Single Tank) or Fuel Tank Replacement (Single Tank w/5.3L (L59) Engine) or Fuel Tank Replacement (Dual Tanks - Front) or Fuel Tank Replacement (Dual Tanks - Rear) .
- Disconnect and remove the EVAP pipe (1) from the roll over valve (3), sending unit (2) and retaining clips (6).
- Cap the sending unit, fuel tank roll over valve in order to prevent possible EVAP system contamination.
Fig 1: View Of Fuel Feed, Return & EVAP Pipes, Sending Unit, Rollover Valve & Fuel Tank Clips (1500 Series - 5.3L - L59)