LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System - 4.8L, 5.3L & 6.0L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement (2500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Canister Vent Solenoid Electrical Connector (2500 Series)
    GM1224403Courtesy of GENERAL MOTORS CORP.
  1. If necessary, install and connect the CVS line. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  2. Install the CVS and line.
  3. Engage the retaining tab on the CVS bracket (2).
  4. Connect the CVS quick connect fittings at the canister. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  5. Connect the EVAP canister vent solenoid (CVS) electrical connector (1).
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals