LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System - 4.8L, 5.3L & 6.0L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement (1500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of CVS Quick Connect Fitting & Retainer
    GM1346845Courtesy of GENERAL MOTORS CORP.
  1. Pry out the retainer on the CVS bracket (2) in order to engage the CVS.
  2. Slide the CVS onto the bracket. Ensure the CVS engages.
  3. Install the harness clip to the CVS line.
  4. Connect the CVS quick connect fitting (1). Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    5. Fig 2: View Of Canister Vent Solenoid (CVS) Electrical Connector (1500 Series)
    GM1346846Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the canister vent solenoid (CVS) electrical connector (1).
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals