LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Avalanche 2500 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System - 4.8L, 5.3L & 6.0L (Introduction)) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: Perform the CKP System Variation Learn Procedure  whenever the crankshaft position sensor is removed or replaced.
    Fig 1: View Of CKP Sensor Electrical Connector
    GM1236361Courtesy of GENERAL MOTORS CORP.
  1. Remove the starter. Refer to Starter Motor Replacement (4.8L, 5.3L, and 6.0L Engines) or Starter Motor Replacement (8.1L Engine) in Engine Electrical.
  2. Disconnect the crankshaft position (CKP) sensor electrical connector.
    3. Fig 2: View Of CKP Sensor & Bolt
    GM1239292Courtesy of GENERAL MOTORS CORP.
  3. Clean the area around the CKP sensor before removal in order to avoid debris from entering the engine.
  4. Remove the CKP sensor bolt.
  5. Remove the CKP sensor.
scientia non olet · About LEMON Manuals